Bolt-On Reducer Sleeve

The GEN-Y Bolt-On Reducer Sleeve is a steel reducer sleeve that bolts in with set screws to create a solid, anti-rattle connection between two different receiver sizes. Unlike a standard loose-fit reducer sleeve, it's designed to reduce play and movement at the connection point. It requires minimal installation and is available in 2.5 inch to 2 inch and 3 inch to 2.5 inch sizes.

The GEN-Y Bolt-On Reducer Sleeve is available in two sizes: 2.5 inch to 2 inch, and 3 inch to 2.5 inch. There is currently no single sleeve that reduces a 3 inch receiver directly down to a 2 inch shank; see the next question for how to bridge that gap using two sleeves.

Yes. GEN-Y has confirmed that using two Bolt-On Reducer Sleeves together, a 3 inch to 2.5 inch sleeve followed by a 2.5 inch to 2 inch sleeve, works as an alternative to using two traditional loose-fit reducer sleeves, and will drastically reduce play and movement compared to the loose-fit approach.

The Bolt-On Reducer Sleeve uses set screws to bolt in and create a solid connection, rather than simply sliding loosely into the larger receiver the way a standard reducer sleeve does. This reduces slop and rattle at the connection point. Some customers have reported needing to tighten the set screws firmly during installation to get the full anti-rattle benefit; watch GEN-Y's installation video for the correct approach.

This is usually caused by set screws that haven't been tightened enough during installation. GEN-Y recommends tightening the set screws more firmly than you might expect, and watching GEN-Y's installation video for the correct technique. If the sleeve still feels loose after retightening, contact GEN-Y directly at (574) 218-6363 for further troubleshooting.

The GEN-Y Bolt-On Reducer Sleeve (part number GH-007-1) weighs 8 pounds. As a compact steel accessory rather than a full hitch component, it adds minimal weight to your towing setup while closing the gap between two different receiver sizes, whichever size combination you select.

Yes. The GEN-Y Bolt-On Reducer Sleeve is manufactured in the United States from steel with a black powder coat finish. The product page does not list a specific warranty term for this accessory; check GEN-Y's general returns and warranty page or contact GEN-Y directly for current coverage details on this item.